This knife was forged from an implement tine. This should be close to 5150 if the information on the internet is correct. I found it to be a little harder to forge than the 108x.
Continue reading
Knife 41 – Remake – Lots of Mistakes Made
This Knife “The Knife that has been remade” certainly helped with my knife making education. I made a lot of mistakes and most of this Knife is a transition of those mistakes from trial and error and fix this and try that.
Continue reading
Knife 40 – Fully Forged Hunter
Knife 40 – Fully Forged Hunting knife This is the first knife I’m going to call forged. I’ll admit it took me longer due to […]
Continue reading
Knife 39 – Hunting – Larger Skinner – Etching with Ferric Chloride
I have Used Ferric Chloride full strength. Some knife makers suggest diluting it. It will take some experimenting to determine which works best for you.
To make the containers for the ferric acid I took 2 pieces of 3” PVC and plugged one end and added a cap on the top. I found this sand blast medium barrel perfect for a base for a bit more stability. Clamping it to the wall or a post will work as well. You just do not want it to be tipped over.
Continue reading
Knife 38 – kiridashi with Burnt Ash Scales
A Kiridashi is a Japanese style knife usually used as a woodworking marking knife or carving knife. The name ‘Kiridashi’ means ‘to carve out’ in Japanese. The only thing different from the previous kiridashis I made is the burnt ash handles and it was made from a worn-out file.
Continue reading
Knife 37 – Utility/EDC – With File Work
A small utility knife made from a file. I made this knife to try filing on the spline.
Continue reading
Knife 36 – Welded Chef’s Knife/Cleaver
This knife was an experimental knife. I had a piece of low Carbon Tig welded to 1095 high carbon. I like the way this came out and the different look.
Continue reading
Knife 35 – Serbian Cleaver
Knife 35 – Serbian Cleaver Made from 3/16” 1084 Even though I did very little to this before heat treating, I still wound up with […]
Continue reading
Knife 34 – Hidden Tang Aluminum Framed Knife
The jimping was first laid out and cut with the band saw. A hacksaw would work well here if you didn’t have access to a bandsaw. I then started the filing with a triangle edge of a file. I then used a chainsaw file ADD FILE SIZE> to cut the Jimping. I cut 10 Stokes on each hole until the cut marks disappeared. That way I had even depth all the way across. (See Adding Jimping to your knife)
Continue reading
Knife 33 – Hidden Tang Antler Handled Hunter
The Knife 33 – Hidden Tang Antler Handled Hunter knife was made from a file using the stock removal technique. You can burn the antler in. Like burning in a wood handle. You drill a hole smaller than the tang. Heat the tang and push the handle down on the tang so it burns in. You repeat the process until the handle is in place. You’d want to do this before heat treating or wrap the blade with a wet cloth. I tried this process, but it didn’t work very well on this antler so I decided to file it out.
Continue reading